[Elphel-support] 10393 for 3 KAI11002 at 4.8 fps(30mhz)

[support-list]

Yakov,

Just one will definitely be enough, but there is no code to run these sensor boards. And as these sensors are rather old it may be easier to just use NC323 than to develop firmware fro the 393 to run these sensors.

Andrey

---- On Sat, 02 Jul 2016 19:07:02 -0700 Yakov<queilasha at gmail.com> wrote ---- 

Hello Andrey. How many 10393 CPU boards I need to run 3 KAI11002 at 
4.8 fps at 30mhz? 
 
Regards, 
Iakov(Yakov) Petrov. 
 
On Mon, Aug 24, 2015 at 11:24 PM, support-list 
<support-list at support.elphel.com> wrote: 
> Hello Yakov, 
> 
> The 10393 boards (main boards of the NC393 cameras) are hardware-compatible 
> with the older sensor boards. The new system board has 4 identical ports 
> each with the pinout compatible with 10313, 10333 and 10353 boards. The new 
> camera will also support modern serial sensor interfaces, but the bakward 
> compatibility will be 100% preserved - with the flexibility of FPGA it is 
> not that difficult. 
> 
> I just finished simulation of the camera FPGA (comparing against 10353 with 
> the same sensor data) and now I'm starting to test it on the actual hardware 
> 
> 
> Andrey 
> 
> Hello. Will NC393 boards will be backward compatible with 323 hardware? 
> 
> Best regards, 
> Yakov Petrov. 
> 
 
_______________________________________________ 
Support-list mailing list 
Support-list at support.elphel.com 
http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com 





-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://support.elphel.com/pipermail/support-list_support.elphel.com/attachments/20160702/904935b3/attachment-0002.html>