[Elphel-support] 10393 for 3 KAI11002 at 4.8 fps(30mhz)

[Yakov]

Yeah. But these sensors are CCD and have global shutter. Ideal for
book scanning in industrial scale.
How much will be to write such a firmware for 10393? Do you have
firmware for 10353? Maybe some other sensor boards can be developed
based on 25MP CMOS global shutter sensors?

Regards,
Iakov(Yakov) Petrov.

On Sun, Jul 3, 2016 at 7:21 AM, support-list
<support-list at support.elphel.com> wrote:
> Yakov,
>
> Just one will definitely be enough, but there is no code to run these sensor
> boards. And as these sensors are rather old it may be easier to just use
> NC323 than to develop firmware fro the 393 to run these sensors.
>
> Andrey
>
> ---- On Sat, 02 Jul 2016 19:07:02 -0700 Yakov<queilasha at gmail.com> wrote
> ----
>
> Hello Andrey. How many 10393 CPU boards I need to run 3 KAI11002 at
> 4.8 fps at 30mhz?
>
> Regards,
> Iakov(Yakov) Petrov.
>
> On Mon, Aug 24, 2015 at 11:24 PM, support-list
> <support-list at support.elphel.com> wrote:
>> Hello Yakov,
>>
>> The 10393 boards (main boards of the NC393 cameras) are
>> hardware-compatible
>> with the older sensor boards. The new system board has 4 identical ports
>> each with the pinout compatible with 10313, 10333 and 10353 boards. The
>> new
>> camera will also support modern serial sensor interfaces, but the bakward
>> compatibility will be 100% preserved - with the flexibility of FPGA it is
>> not that difficult.
>>
>> I just finished simulation of the camera FPGA (comparing against 10353
>> with
>> the same sensor data) and now I'm starting to test it on the actual
>> hardware
>>
>>
>> Andrey
>>
>> Hello. Will NC393 boards will be backward compatible with 323 hardware?
>>
>> Best regards,
>> Yakov Petrov.
>>
>
> _______________________________________________
> Support-list mailing list
> Support-list at support.elphel.com
> http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
>
>
>