[Elphel-support] Bad line-scan output

[Linden Mills-Connery]

I was just talking to the client and they have a large event next weekend
and would like to have this resolved by then. What email can I send you the
ship to address?

Thanks,

Linden Mills-Connery
Zone4 Team <http://new.zone4.ca/contact>
205-820 Main Street
Canmore, AB, T1W2B7
403-401-7215


On Fri, Apr 25, 2014 at 12:18 PM, Linden Mills-Connery <lmillsc at gmail.com>wrote:

> Sounds good. Is this just the sensor board at the front that will be
> replaced? I would like to ship directly to the client (Louisiana). How do
> we proceed?
>
> Linden
>
>
> On Thursday, April 24, 2014, Oleg <support-list at support.elphel.com> wrote:
>
>> Hi,
>>
>> On the screenshots it looks ok.
>>
>> The further thoughts:
>> It might be bad sensor initialization at power up. I've seen this but
>> don't know what causes it - normally power cycle fixes the problem and the
>> pictures don't get bad during the work.
>>
>> We can replace the board in the camera so we could have a close look at
>> it.
>>
>> Best regards,
>> Oleg Dzhimiev
>> Electronics Engineer
>> phone: +1 801 783 5555 x124
>> Elphel, Inc.
>>
>
>
> --
> Linden Mills-Connery
> Zone4 Team <http://new.zone4.ca/contact>
> 205-820 Main Street
> Canmore, AB, T1W2B7
> 403-401-7215
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://support.elphel.com/pipermail/support-list_support.elphel.com/attachments/20140425/e804b00e/attachment-0002.html>