[Elphel-support] binning modes, sum and average, how to change them?

[Sebastian Pichelhofer]

Why are you writing an URL into the terminal?

try wget with localhost as camera address.

Regards Sebastian

On Fri, Oct 12, 2012 at 7:55 PM, Biel Bestué de Luna <7318.tk at gmail.com>wrote:

> I'm with firmware: Elphel (R) Model 353 Camera release 8.2.8
>
> I'm trying to change between binning modes, and I'm using the information
> in the wiki <http://wiki.elphel.com/index.php?title=Binning> to change
> the Binning mode:
> http://*cameraIP*/parsedit.php?embed=0.18&SENSOR_REGS32 in my case
> *cameraIP* is "elphel" which is an alias for "192.168.1.9" that i have set
> up in my computer.
>
> When I'm connected to the camera, and I write this on the terminal the
> terminal responds with the following error message:
>
> ~$ http://elphel/parsedit.php?embed=0.18&SENSOR_REGS32
>
> [1] 2738
> bash: http://elphel/parsedit.php?embed=0.18: The file or directory
> doesn't exist
> SENSOR_REGS32: command not found
> [1]+  End of execution with state 127
> http://elphel/parsedit.php?embed=0.18
>
> I've searched SENSOR_REGS32 in the parameter editor but it isn't seem to
> be there, I couldn't find it! how do I change the binning mode?
>
>
> _______________________________________________
> Support-list mailing list
> Support-list at support.elphel.com
> http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://support.elphel.com/pipermail/support-list_support.elphel.com/attachments/20121012/d461dd8c/attachment-0002.html>