[Elphel-support] 359 - 3 sensor setup

[Andreas Bean]

Andrey,

Currently we are testing a 3 sensor setup with a 359 board. Its 
basically working, but the connected to J4 shows some sort of problems. 
Green and purple pixels in high brightness regions.
We have 3 359RevA boards and 5 10338RevD here.
I also interchanged the 359 and 10338 boards - always the same result: 
J2,J3 is working fine, J4 sensor is delevering bad pixels.

Important also:
We have connected the sensors with an 8" ffc cable
The firmware revision is 8.0.8.48

Do you think is a software or hardware problem?

Andreas