[Elphel-support] how do I reflash the camera via netboot mode?

[Elphel Support | Sebastian Pichelhofer]

On Tue, Nov 2, 2010 at 19:40, Andrey Filippov <andrey at elphel.com> wrote:
> On 11/2/10, Ákos Maróy <akos at maroy.hu> wrote:
>> Andrey,
>
>> actually, this web interface resets the IP address, but not the gateway
>> or the broadcast address. I was looking in /etc to find where these
>> settings are saved, but didn't find then there..
>>
>> where would I change these manually, via an ssh connection?
>>
>>
>> Akos
>>
>
> Akos,
>
> Sebastian will look at the problem of not changing those settings and
> try to reproduce your case. He may need more input from your.

Yes please describe as accurate as you can what fields you filled with
which values in which order and what the results were!.

Or do you have screenshots?

Regards Sebastian



> Changing those settings manually  permanently can be done through the
> browser (there is a link on the camera home page)
> http://192.168.0.9/admin-bin/editcgi.cgi?file=/etc/conf.d/net.eth0
>
> But after changing that file I would recommend to synchronize the
> camera JFFS file system, to keep it happy (i.e. with
> wget http://192.168.0.9/phpshell.php?command=sync
> or opening that link in the browser,  otherwise camera will complain
> about checksum mismatch at every boot in the messages (dmesg) until
> that particular block will be overwritten. Command
> reboot -f
> would synchronize too.
>
> Andrey
>