[Elphel-support] 答复: 答复: sync stereo with lidar

[Tao Zhang]

so we need to buy a 103696 board. after we have the board, we need to open the shell to connect to j8 and j9，but then we will not be able to close the shell，right? can you give an instructions of how to connect that board to 10393 camera. And can you give a quotation of this board plus imu board and a ADI 1xx40 imu?
Thanks

Tao Zhang



发件人: Oleg
发送时间: 5月9日星期三 00:36
主题: Re: [Elphel-support] 答复: 答复: sync stereo with lidar
收件人: Tao Zhang
抄送: Winston Zhang, Qun Gu, David Zhang, elphel support-list


Hello,

Did you mean this question?
We have Garmin GPS 18x 5Hz GPS receiver bought from you. How should we connect GPS to stereo camera? Shall we have a 103696 board? But I can not find how to connect it to 10393 camera on 103696 introduction page (-https://wiki.elphel.com/wiki/103696).

For 10393 you should have 10389 board (https://wiki.elphel.com/wiki/10389)

Garmin GPS 18x 5Hz GPS - is it serial? or usb?
If usb then use a eSATA+USB port or micro usb port
If serial then you need to have 103696 - 103696 is connected to J8 or J9 ports of 10389 with 10-contact flat cable.

Best regards,
Oleg Dzhimiev
Electronics Engineer
phone: +1 801 783 5555 x124
Elphel, Inc.


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://support.elphel.com/pipermail/support-list_support.elphel.com/attachments/20180510/66f3fca9/attachment.html>