[Elphel-support] Back to life 313 camera

[Artem Astafyev]

Hi Andrey,

How can I check this? Are there any photos of proper wiring? I tried to
unplug/plug cable between main board and sensor but nothing has changed.
But maybe I missed something.

On Tue, Dec 9, 2014 at 6:51 PM, support-list <
support-list at support.elphel.com> wrote:

> Artem,
>
> Seems like the camera does not see the sensor - bad cable connection?
>
> Andrey
>
>
> removing MRST from the sensor, setting DMA burst size, setting MCLK to
> 20MHz
>
> sensor power set low
>  will set to 0x41
> will set to 0x30
> will set to 0x28
> will set to 0x24
> will set to 0x22
> .. full
> Inverted MRST, ccam_cr_shadow= 8002a040
> trying MT9X001
> sensor id= 0x0
> No image sensor found
> MCPSendA returned 0
> Should return -1!! 0
> no MCP module detected
> FPGA rev 3130059
> Programmed linear intensity table (gamma=1.0)
> Camera interrupts enabled
> removing MRST from the sensor, setting DMA burst size, setting MCLK to
> 20MHz
> sensor power set low
>  will set to 0x41
> will set to 0x30
> will set to 0x28
> will set to 0x24
> will set to 0x22
> .. full
> trying MT9X001
> can not program unknown/unexistent sensor
>
>
>


-- 
Best regards,
Artem Astafyev
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://support.elphel.com/pipermail/support-list_support.elphel.com/attachments/20141210/e5f0afd0/attachment-0002.html>