[Elphel-support] Back to life 313 camera

[support-list]

Artem,

Seems like the camera does not see the sensor - bad cable connection?

Andrey

removing MRST from the sensor, setting DMA burst size, setting MCLK to 20MHzsensor power set low
 will set to 0x41
will set to 0x30
will set to 0x28
will set to 0x24
will set to 0x22
.. full
Inverted MRST, ccam_cr_shadow= 8002a040
trying MT9X001
sensor id= 0x0
No image sensor found
MCPSendA returned 0
Should return -1!! 0
no MCP module detected
FPGA rev 3130059
Programmed linear intensity table (gamma=1.0)
Camera interrupts enabled
removing MRST from the sensor, setting DMA burst size, setting MCLK to 20MHz
sensor power set low
 will set to 0x41
will set to 0x30
will set to 0x28
will set to 0x24
will set to 0x22
.. full
trying MT9X001
can not program unknown/unexistent sensor






-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://support.elphel.com/pipermail/support-list_support.elphel.com/attachments/20141209/f346906e/attachment-0002.html>