[Elphel-support] change the IP to a subnet like 192.168.0.xx (like in the original configuration)

[Biel Bestué de Luna]

ok ok ok :D thank you very much!


2013/4/2 Oleg <support-list at support.elphel.com>

> Biel,
>
>> In case of me making some mistake and screwing it up, how could I recover
>> it? Would I have to send my camera off?
>>
> It's unlikely something could go wrong here. Just remember your settings.
> In any case you would be able boot the camera through the network provided
> you boot a live usb on your PC.
>
>> in order to have an IP from the device in the xx.xx.0.xx subnet (factory
>> settings) do I change only the IP value to the new subnet (from 192.168.1.9
>> to 192.168.0.9)? Or do I have to change Netmask, Gateway, and the Broadcast
>> to some other value also?
>>
> Normally, you should change the gateway to 192.168.0.1 (or whatever your
> router's ip address is) and broadcast 192.168.0.255, netmask stays the
> 255.255.255.0.
> In short, the camera's address needs to be in the same subnet to be
> accessible - meaning if it stays connected to the same router - the
> router's wire address has to be changed to 192.168.0.1.1...254.
>
> So, first change the camera address then, the router's address.
>
> Best regards,
> Oleg Dzhimiev
> Electronics Engineer
> phone: +1 801 783 5555 x124
> Elphel, Inc.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://support.elphel.com/pipermail/support-list_support.elphel.com/attachments/20130402/58d6bc2c/attachment-0002.html>