[Elphel-support] strreaming problem...

[Carlos Padial]

i had a problem with the streaming...

i start the camera and launch a simple stream viewer with:
gst-launch rtspsrc location=rtsp://192.168.0.9:554 latency=100 !
rtpjpegdepay ! jpegdec ! autovideosink

and i can see the video working fine.

Then i go to camcv and set the sensor to 1920x1088 (or 1280x720) (i tried
also limitting the framerate and manual exposure...)

when i launch again gstreamer, the stream never start, and the network
stops working. The camera remains with green and yellow leds on, and the
Internet conection is collapsed for all computers in the net until i
restart the camera.

it has been happening a lot of times. Normally gstreamer and vlc are only
able to see the strream when working at full resolution. Sometimes the
gstreamer shows the video with other resolutions, and works fine, but
suddenly it fails and i cant find a reason for this...

(the camera freezes only when reading the stream. When recording from
camogmgui it works ok at any resolution)

any ideas?

-- 
Carlos Padial
surreal.asturnazari.es
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://support.elphel.com/pipermail/support-list_support.elphel.com/attachments/20120516/64e78b3b/attachment-0002.html>