[Elphel-support] 353 Processor

[Aaron Wilkes]

Hi Oleg,

Thanks for the response,

Do you have any planned dates for the next generation?

Regards

Aaron

On 23 March 2012 17:39, Oleg <support-list at support.elphel.com> wrote:

> Hi, Aaron
>
>
> I have been looking at the open hardware 353 camera that you have on your
>> website, and noticed that you state you use the AXIS ETRAX FS, now I’m sure
>> you know it has been discontinued since 2010, do you have a replacement for
>> this part? I assume any ARM based processor will do?
>
>
> The next generation of the system board is in planned. It's on hold until
> the other big project is finished.
>
>
>> Does the code have anything specific to the ETRAX or can it be used on
>> any Linux distribution?
>
>
> Most of the C code is not ETRAX specific (cross compiler deals with that).
> But there are parts for the boot where special instructions could be used
> (haven't seen it myself) like direct memory access.
>
> Best regards,
> Oleg Dzhimiev
> Electronics Engineer
> phone: +1 801 783 5555 x124
> Elphel, Inc.
>
> On 21 March 2012 12:45, Aaron Wilkes <wilksey at gmail.com> wrote:
>
>> Hi,
>>
>>
>>
>> I have been looking at the open hardware 353 camera that you have on your
>> website, and noticed that you state you use the AXIS ETRAX FS, now I’m sure
>> you know it has been discontinued since 2010, do you have a replacement for
>> this part? I assume any ARM based processor will do? Does the code have
>> anything specific to the ETRAX or can it be used on any Linux distribution?
>>
>>
>>
>> Kind Regards
>>
>>
>>
>> Aaron
>>
>> _______________________________________________
>> Support-list mailing list
>> Support-list at support.elphel.com
>> http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
>>
>>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://support.elphel.com/pipermail/support-list_support.elphel.com/attachments/20120323/c2fed85a/attachment-0002.html>