[Elphel-support] hdd without partition

[Carlos Padial]

ok, tomorrow i'll  check the connector and send you photos.

thanks

2012/3/20 Oleg <support-list at support.elphel.com>

> Well, could you please double check the fixed connector?
> 1. Try gently touching a pin with a needle and see if any of them moves.
> 2. I'd also check the connector pins for short circuit.
>
> It seems to be the only place.
> How was it tested? Did you use the circuit diagram of the 10369?
> Could you send a picture of the connector?
>
> Regards,
> Oleg
>
> On 19 March 2012 16:48, Carlos Padial <palidoestudio2 at gmail.com> wrote:
>
>> i get this
>> -----------
>>
>> Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
>>
>> ide: Assuming 50MHz system bus speed for PIO modes; override with
>> idebus=xx
>>
>> ide: ETRAX FS built-in ATA DMA controller
>>
>> cris_ide_init()
>>
>> Initializing USB Mass Storage driver...
>> -----------
>>
>> i hear the disk when starting the camera and the motor stopping when
>> switching off, and a little zzz while working.
>>
>>
>> 2012/3/19 Oleg <support-list at support.elphel.com>
>>
>>> Also, can you here the noise when the HDD is working?
>>
>>
>>
>>
>> --
>> Carlos Padial
>> surreal.asturnazari.es
>>
>> _______________________________________________
>> Support-list mailing list
>> Support-list at support.elphel.com
>> http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
>>
>>
>


-- 
Carlos Padial
surreal.asturnazari.es
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://support.elphel.com/pipermail/support-list_support.elphel.com/attachments/20120320/166627f4/attachment-0002.html>