[Elphel-support] Synchronizing with an external flash
Eric Boudrand
dev at boudrand.net
Sat Jul 21 08:29:35 PDT 2012
Hello
> Of course it only works if the camera is in triggered mode.
> http://wiki.elphel.com/index.php?title=Trigger
Some questions are raising while reading the documentation pages.
http://wiki.elphel.com/index.php?title=Synchronizing_353
I have plugged a 4P4C connector with a 4-wires cable to J15. Is this
connector GPIO[11] ? I have chosen to use PIN 2 on that connector.
I am using between the J15 connector and the external flash a LD117 with
an adjustable output voltage (using a potentiometer). I must be cautious
because I can damage my flash in case of incorrect voltage...
Should my Elphel settings be the following ones ?
TRIG = 4
TRIG_CONDITION = 0
TRIG_OUT = 0x400000 (I'm using bit 22)
TRIG_PERIOD = 1
TRIG_BITLENGTH = 31
EXTERN_TIMESTAMP = 0
XMIT_TIMESTAMP = 0
Thanks in advance for your help. I am not sure of TRIG_OUT value.
Regards.
Éric Boudrand
More information about the Support-list
mailing list