[Elphel-support] Can't communicate with Elphel353

[Diana Carrigan]

No I did not configure anything...

Diana

From: elphel at gmail.com [mailto:elphel at gmail.com] On Behalf Of Andrey Filippov
Sent: Friday, September 02, 2011 8:17 AM
To: Diana Carrigan; support-list at support.elphel.com
Subject: Re: [Elphel-support] Can't communicate with Elphel353


On Fri, Sep 2, 2011 at 7:59 AM, Diana Carrigan <DianaEJohnson at maxim-ic.com<mailto:DianaEJohnson at maxim-ic.com>> wrote:
We have not changed any code in the camera. I power cycled the camera and now we can not communicate to it thru Ethernet or the Serial cable connected to the 10369 IO board.

Diana, you wrote that the serial cable was connected to the camera. Before you lost communication with the camera - did you configure some terminal emulator (i.e. minicom) to see camera boot messages on the system console?

If yes - what happens now on that port?

The baud rate on the port is 115k.

Andrey

Prior to power cycling the camera we could communicate and run video and camera applications. The Ethernet green and yellow lights are blinking, and the light on the power supply is green.

Any suggestions?

Diana Carrigan

_______________________________________________
Support-list mailing list
Support-list at support.elphel.com<mailto:Support-list at support.elphel.com>
http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://support.elphel.com/pipermail/support-list_support.elphel.com/attachments/20110902/916a0d40/attachment-0002.html>