[Elphel-support] Elphel353

[Diana Carrigan]

Thanks. I somehow read a previous email incorrectly...too much going on.

This was very helpful.

Diana
From: elphel at gmail.com [mailto:elphel at gmail.com] On Behalf Of Andrey Filippov
Sent: Thursday, September 01, 2011 11:21 AM
To: Diana Carrigan
Subject: Re: [Elphel-support] Elphel353

Diana,

What do you mean by "10353 System Development board"? For development we recommend 10369 board - http://wiki.elphel.com/index.php?title=10369  (multiple interfaces including serial port for system console), but our records show you already have one in your camera. The system console is available on a 6-pin connector on the side of the camera, if you did not use it yet it is closed by a small lid with 2 screws (if not in use it is better to kip it closed - some light can reach the sensor from the back side). There is a grey 6-conductor "telephone" cable and an adapter to connect 9-pin serial cable or USB-to-serial adapter, also included with the camera.

Andrey
On Thu, Sep 1, 2011 at 11:08 AM, Diana Carrigan <DianaEJohnson at maxim-ic.com<mailto:DianaEJohnson at maxim-ic.com>> wrote:
We have our Elphel353 camera up and running. We would like to observe "video stream" without actually recording. What is the best way to do this?

Also, we are ordering 10353 System Development board. Does the board just connect to the existing camera? If so, thru which interface.

Best Regards,
Diana Carrigan

_______________________________________________
Support-list mailing list
Support-list at support.elphel.com<mailto:Support-list at support.elphel.com>
http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://support.elphel.com/pipermail/support-list_support.elphel.com/attachments/20110901/838fcf13/attachment-0002.html>