[Elphel-support] 10338 board

[Adam Gobi]

Thanks Andrey.  Is it at all possible for the board to operate with 3.3V
LVTTL I/O instead of 2.5V?  I noticed in the sensor datasheet that its max
input HIGH voltage is 3.3V.

Best regards,
ag.

On 17 March 2011 03:52, Andrey Filippov <support-list at support.elphel.com>wrote:

> Adam,
> http://wiki.elphel.com/images/7/71/10338d.pdf has the PCB layout, the
> connector is on the pages showing LAYER-4 (BOTTOM SIDE), the layer is shown
> as seen from top side.
>
> On you image the pin 1 is on the bottom left side, pin 2 - on top left, pin
> 3 - second from the left on bottom, etc.
> These pins do not include the for mounting pins (no electrical contact)
> that are in the 4 corners of the connector:
> X-2-4-6...30X
> X1-3-5-7...29-X
> "X" - mounting pin, no connection to the cable
> "-" - space
> "1".."30" - electrical pin
>
> The cable (sensor end) when pointed sensor end up, looking at the contact
> side will be numbered sequentially 1-2-3-...-29-30
>
>
> On Tue, Mar 15, 2011 at 10:03 PM, Adam Gobi <adam.gobi at acheron.com.au>wrote:
>
>> Thanks for your reply Andrey, but I couldn't see what you were referring
>> too.  Instead, I've attached a picture to remove any potential ambiguousness
>> from my original question of left, or right.
>>
>> Thanks,
>> ag.
>>
>>
>


-- 
Adam Gobi
Lead Engineer - Imaging
Acheron Project Pty Ltd
Leichhardt, NSW, Australia
e: gobi at acheron.com.au <adam.gobi at acheron.com.au>
v: +61 451 951 323
f: +61 2 9571 5575
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://support.elphel.com/pipermail/support-list_support.elphel.com/attachments/20110321/9e3b8443/attachment-0002.html>