[Elphel-support] problem with stereo setup
Jorick Astrego
jorick at netbulae.com
Wed Aug 11 04:33:00 PDT 2010
Dear Andrey/Oleg,
We disassembled the 359 and sensors and tested them all directly on the
camera and they all work ok. When can we use the new CVS code? I've seen
a lot of commits already :-)
Thank you for all your efforts as we know you guys are very busy with
the Eyesis and that's looking very nice already.
Regards,
Jorick
On 08/10/2010 04:55 PM, Andrey Filippov wrote:
> Oleg,
>
> Yes the log shows that the sensors were never triggered, but I would
> rather zero out the TRIG_CONDITION parameter. The code I'm testing now
> distinguishes between Eyesis mode and other 10359 applications and
> program default /etc/autocampars.xml accordingly. For Eyesis camera
> will use hardware inter-camera synchronization by default, other 10359
> applications - internal trigger (TRIG=4, TRIG_CONDITION=0), 353
> without the 10359 board will default to TRIG=0. In most multi-sensor
> setups (but the simple one where 10359 is used just as a multiplexor
> to switch between different sensors (i,e, day/night) the sensors
> should run synchronized. And the current code is built around it, it
> needs TRIG=4 mode,
>
> Andrey
More information about the Support-list
mailing list