[Elphel-support] 10359

[Andreas Bean]

Hello Oleg, hello Andrey!

I was thinking about a new mode for 10359 FPGA for combining the the
pictures of two sensors. In this new setup the multiplexer board puts
the second image beside the first one. For my setup (1296x960px per
sensor) the final picture would be 2592 x 960px.
It would be better because the frames can then be recorded to quichtime
movie and the auto exposure covers both pictures.
Do you think this can be done easily?

Best wishes,
Andreas Bean

Oleg Dzhimiev schrieb:
> Hi Andreas,
>  
>
>     During the last days I have mounted the 10359 board inside the camera
>     below the 10353 board. Two sensor boards are connected via a 6
>     inch flex
>     cable. With your description I was able to switch the board to
>     triggered
>     mode and I was able to test the first sensor. Additionally with the
>     phase adjust page I was able to remove wrong pixels which were
>     caused by
>     the longer flex cable. So the first sensor board is working fine.
>     I was
>     not able to switch to the second one, simply because I don't know
>     how to
>     do that.
>
>
> You can switch to the other channel in two ways:
> 1. http://192.168.0.9/359/reg_write.php?adr=0x835&data=2
> <http://192.168.0.9/359/reg_write.php?adr=0x835&data=2> - that will be
> the second channel (J3)
>     http://192.168.0.9/359/reg_write.php?adr=0x835&data=4
> <http://192.168.0.9/359/reg_write.php?adr=0x835&data=2> - 3rd channel
> (J4) - the most distant from the cable to 10353
>
> 2. or if you have firmware >8.0.5.2 you can try
> http://192.168.0.9/359/10359_controls.html - and there you can find a
> field for switching a channel - 1,2 or 4, and you also can try to
> autoadjust phases.
>
>     What I want to do is to record single framers which are captured
>     simultaneously  and  then  written  separately to disk using the
>     camogm
>     utility at a resolution of 1280x1024 at 40fps. Can you give me a short
>     description what I will have to do to achieve that?
>
>
> Alternating frames 1280x1024 at 20fps from each channel that in sum will
> give 40fps? Here I need to make a small revision of my previous work
> while you are adjusting phases I checked CVS - and there's at least
> one script is missing.
> Basically, what you'll need to do is:
> 1. Switch to broadcast channel (0x7) to program both sensors to the
> resolution you need.
> 2. Put sensors to triggered mode
> 3. Switch on the alternation mode with buffering on 10359.
> 4. and then use camogm to record frames
>
> Oleg
> ------------------------------------------------------------------------
>
> _______________________________________________
> Support-list mailing list
> Support-list at support.elphel.com
> http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
>   

-------------- next part --------------
A non-text attachment was scrubbed...
Name: office.vcf
Type: text/x-vcard
Size: 233 bytes
Desc: not available
URL: <http://support.elphel.com/pipermail/support-list_support.elphel.com/attachments/20091101/8dadac30/attachment.vcf>