[Elphel-support] sensor board, informations

[Elphel Support]

Hello Julie,

I'm afraid we can not help you with the sensor boards compatible with Raspberry Pi - our sensor boards are only compatible with the earlier Elphel cameras, designed more than 10 years ago. All our sensor boars use the 30-conductor flex cables - we can use both standard 0.5 mm pitch flex cables and our improved (shielded signals, thick power lines) ones, compatible with both parallel (up to 14 bit) and high speed serial (up to 8 differential pairs + clock pair).

All Elphel cameras are designed around FPGA that is used for image processing/compression - it is not the case with the Pi.

Andrey

---- On Fri, 10 Feb 2017 03:17:48 -0800 julie<julie-go at jaming.fr> wrote ---- 

  Hi, :-)
  I'm in a french team of film makers, and we want to build an open source camera. We are looking for an high or average definition (at least 1920x1080) open source Sensor Board compatible with raspberry Pi,  that could allow use to use any objective (including old photographic objective). We wanted to create a snapPi cam but with a better sensor board that the ones sold by adafruit Raspberry pi compagny. 
 
 I see you sell a lot of open hardware  camera components (393...) including sensor boards, do you have any sensor compatible with Raspberry Pi  ?
 What connexions do you use for your sensor boards ? 
 
 Yours sincerely 
 
 
 
 Julie Go
 
 
 
 _______________________________________________ 
Support-list mailing list 
Support-list at support.elphel.com 
http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com 





-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://support.elphel.com/pipermail/support-list_support.elphel.com/attachments/20170210/99df1b58/attachment-0002.html>