[Elphel-support] Interface board 10342 vs Sensor board 10324(?)

[support-list]

Yakov,

Honestly - I do not remember all the details. One thing was that 10324 was split it two parts (10342 and 10347) to support
KAC16000 (with 10344 instead of 10342). And there were definitely some improvements. There was only a small batch of 10342+10347 boards made for the street view experiments, and we have only one 363 camera.

10393 board physical interface is compatible, just two feedback resistors should be replaced as the interface voltage range regulation is not large enough (1.8V to 2.8V) and the 10324 uses 3.3V. Zynq is compatible with 3.3V, just the programmable voltage regulators need this change.

Andrey

---- On Fri, 22 Jul 2016 11:05:38 -0700 Yakov<queilasha at gmail.com> wrote ---- 

Hello Andrey. What the difference between 10324 and 10342? What the 
newest sensor board for KAI-11002 sensor. Can move sensors from my 
camera boards to newer boards? Is there any point of preserving 
anything from NC323-2 Camera besides KAI-11002 sensor and the case? 
What set of hardware I will need to run 3 KAI-11002 on 10393 boards? 
 
Currently writing requirement for 10393 firmware for "axonim". 
Regards, 
Iakov(Yakov) Petrov. 
 
_______________________________________________ 
Support-list mailing list 
Support-list at support.elphel.com 
http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com 





-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://support.elphel.com/pipermail/support-list_support.elphel.com/attachments/20160722/1b69ed56/attachment-0002.html>