[Elphel-support] Elphel 323

[Yakov]

Hello Andrey. I will still need two 10353 boards for each camera? It means
I will need 6 boards for all the project.

Regards,
Yakov.

On Fri, Aug 21, 2015 at 11:56 PM, support-list <
support-list at support.elphel.com> wrote:

> Hello Yakov,
>
> Running KAI11002 at higher pixel rate decreases the dynamic range, and the
> Model 323 was designed to provide full dynamic range that sensor can
> provide while the required frame rate for book scanning was just 1 frame
> per 1.5 second. All the timing of the CCD is implemented in the FPGA so it
> is possible to increase the frame rate (you will also need to replace 10313
> boards with 10353 as the older AXIS CPU had limited network bandwidth due
> to software checksum calculation). On the other hand, reducing the dynamic
> range by increasing the frame rate would reduce advantage of that CCD image
> sensor and you will get performance of the newer CMOS image sensors that
> are much easier to operate.
>
> Andrey
>
> ---- On Fri, 21 Aug 2015 09:03:48 -0700 *Yakov <queilasha at gmail.com
> <queilasha at gmail.com>>* wrote ----
>
> Hello. I have one question. It's mentioned in that model 323 can only
> shoot 2 fps. But it's  matrix can do 4.8 fps at 30mhz. Can model 323 can be
> somehow upgraded to do 4.8 fps?
>
> Best regards,
> Yakov Petrov.
> _______________________________________________
> Support-list mailing list
> Support-list at support.elphel.com
> http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
>
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://support.elphel.com/pipermail/support-list_support.elphel.com/attachments/20150822/c8824b4b/attachment-0002.html>