[Elphel-support] Fwd: Uncaught bounce notification

[andrey]

This message was received to "support-list-bounces at support.elphel.com" instead of "support-list at support.elphel.com", so I'm forwarding it to the right one.

Andrey


============ Forwarded message ============
>From : mailman-bounces at support.elphel.com
To :  <support-list-owner at support.elphel.com>
Date : Tue, 28 May 2013 04:45:44 -0700
Subject : Uncaught bounce notification
============ Forwarded message ============

The attached message was received as a bounce, but either the bounce 
format was not recognized, or no member addresses could be extracted 
from it. This mailing list has been configured to send all 
unrecognized bounce messages to the list administrator(s). 
 
For more information see: 
http://support.elphel.com/mailman/admin/support-list_support.elphel.com/bounce 
 
 


========================= Forwarded message =========================

Subject: camera recording onto usb stick problem
From: "Gergely Debreczeni"
Date: Tue, 28 May 2013 11:45:44 +0000
To: "support-list-bounces at support.elphel.com"

------------------------- Contents -------------------------

   Dear Support,

 
 
 I’m trying to record some movie to the USB stick plugged into the camera

 In the following way:

 
 
 a.)    Set the camera to triggered mode through the camera control web interface and  set the fps

 The web interface shows the FPS I’ve just set so seems to be OK, so far.

 b.)    telnet to the camera

 c.)     start a camera with: camogm /var/state/camogm_cmd

 d.)    killall autoexposure; killall camogm;

 e.)    echo “status; exif=1; format=mov; duration=60000; length=10000000000; prefix=test; start;” >/var/state/camogm_cmd

 
 
 
 
 However I have the following problems:

 1.)    The recording starts much later than I launch the command

 2.)    The recording stops after a couple of seconds and I’m not able to record long movies

 3.)    There is a message always appearing

 Camogm.c: line 1362 got broken frame (-1) before waiting for ready

 Ending recording

 Starting recording

 Started OK

 
 
 Note: I’m able to record arbitrary long movies with recording the rtsp stream of the camera with ‘mencoder’ on a remote computer.

 
 
 I.)  What I would like is to be able to record long movies using command line instructions on the camers. How can I do that ?

 II.) Is it also possible to set/edit the various camera parameters from the command line ?

 
 
 Thanks a lot,

 Gergely

 
 
 
 
 
 

====================== End of Forwarded Mail ======================